Depress and hold the smoke detector's test switch. ![]() To test for signal strength, activate the wireless system's GO/NO GO TEST mode from the keypad. If a tamper trouble condition was caused by removing the 5808W3 from the base, disarm the system twice to clear the trouble display.Īlways test the smoke detector for signal strength after changing the battery. Reinstall the smoke detector onto the mounting base by insertnig, then turning the smoke detector clockwise. Follow the polarity diagram inside the compartment to install the battery correctly. Install a new 3-volt CR123A Lithium battery in the battery compartment. To ensure proper power-down sequence, wait a minimum of 20 seconds before installing the new battery. ![]() The 5808W3 is tamper protected, so this will cause a trouble condition to be displayed on the alarm panel, unless the panel is in program mode, or powered down. To change the battery in a Honeywell 5808W3 smoke detector, remove the detector from its mounting base by twisting the smoke detector counterclockwise.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |